AudioCodes E-SBC

CHAPTER18 Core Entities
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
'Enable TCP Keepalive'
tcp-keepalive-enable
[SIPInterface_TCPKeepaliveEnable]
Enables the TCP Keep-Alive mechanism with the IP
entity on this SIP Interface. TCP keep-alive can be
used, for example, to keep a NAT entry open for
clients located behind a NAT server, or simply to
check that the connection to the IP entity is available.
■ [0] Disable (default)
■ [1] Enable
Note: To configure TCP keepalive, use the following
ini file parameters: TCPKeepAliveTime,
TCPKeepAliveInterval, and TCPKeepAliveRetry.
'Used By Routing Server'
used-by-routing-server
[SIPInterface_UsedByRoutingServer]
Enables the SIP Interface to be used by a third-party
routing server for call routing decisions.
■ [0] Not Used (default)
■ [1] Used
For more information on the third-party routing server
feature, see Centralized Third-Party Routing Server.
'Pre-Parsing Manipulation Set'
pre-parsing-man-set
[SIPInterface_
PreParsingManSetName]
Assigns a Pre-Parsing Manipulation Set to the SIP
Interface. This lets you apply pre-parsing SIP
message manipulation rules on any incoming SIP
message received on this SIP Interface.
By default, no Pre-Parsing Manipulation Set is
assigned.
To configure Pre-Parsing Manipulation Sets, see
Configuring Pre-parsing Manipulation Rules.
Note:
■ Pre-Parsing Manipulation is done only on
incoming calls.
■ The device performs Pre-Parsing Manipulation
before Pre-Classification Manipulation and
Classification.
'CAC Profile'
cac-profile
[SIPInterface_AdmissionProfile]
Assigns a Call Admission Control Profile (CAC rules)
to the SIP Interface.
By default, no value is defined.
To configure CAC Profiles, see Configuring Call
Admission Control on page756.
Classification
'Classification Failure Response
Type'
classification_fail_
response_type
[SIPInterface_
ClassificationFailureResponseType]
Defines the SIP response code that the device sends
if a received SIP request (OPTIONS, REGISTER, or
INVITE) fails the SBC Classification process.
The valid value can be a SIP response code from 400
through 699, or it can be set to 0 to not send any
response at all. The default response code is 500
(Server Internal Error).
- 337 -