CHAPTER19 Coders and Profiles
Mediant 1000 Gateway & E-SBC | User's Manual
The following procedure describes how to configure the Coder Groups table through the Web
interface. You can also configure it through ini file [AudioCodersGroups] and [AudioCoders], or CLI
(configure voip > coders-and-profiles audio-coders-groups).
➢ To configure a Coder Group:
1. Open the Coder Groups table (Setup menu > Signaling & Media tab > Coders & Profiles
folder > Coder Groups).
2. From the 'Coder Group Name' drop-down list, select the desired Coder Group index number
and name.
3. Configure the Coder Group according to the parameters described in the table below.
4. Click Apply, and then reset the device with a save-to-flash for your settings to take effect.
You can delete a Coder Group, as described in the following procedure.
➢ To delete a Coder Group:
1. From the 'Coder Group Name' drop-down list, select the Coder Group that you want to delete.
2. Click Delete Group.
Table 19-1: Coder Groups Table Parameter Descriptions
Parameter Description
'Coder Group Name'
[AudioCodersGroups_Index]
[AudioCodersGroups_Name]
Defines the name and index for the Coder Group.
Note: The Coder Group index/name cannot be configured.
[AudioCoders_
AudioCodersIndex]
Index row of the coder per Coder Group
Note: The parameter is applicable only to the ini file.
'Coder Name'
name
[AudioCoders_Name]
Defines the coder type. For coder names, see Supported
Audio Coders.
Note: Each coder type (e.g., G.729) can be configured only
once in the table.
'Packetization Time'
p-time
[AudioCoders_pTime]
Defines the packetization time (in msec) for the coder. The
packetization time determines how many coder payloads
are combined into a single RTP packet. For ptime, see
Supported Audio Coders.
- 386 -
To Next Page
Loading...
Need help?
General
