EasyManuals Logo

AudioCodes E-SBC User Manual

AudioCodes E-SBC
1414 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #486 background imageLoading...
Page #486 background image
CHAPTER19 Coders and Profiles
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
'Time For Reorder Tone'
time-for-reorder-tone
[TelProfile_
TimeForReorderTone]
Defines the duration (in seconds) that the device plays a
busy or reorder tone before releasing the line.
Analog interfaces: Typically, after playing the busy or
reorder tone for this duration, the device starts playing an
offhook warning tone.
The valid range is 0 to 254. The default is 0 seconds for
analog interfaces and 10 seconds for digital interfaces.
Note that the Web interface denotes the default value as
"255".
Note:
â–  The selected busy or reorder tone is according to the
SIP release cause code received from IP.
â–  The parameter is also applicable to CAS.
â–  The parameter is applicable to ISDN when the
PlayBusyTone2ISDN parameter is set to 2.
â–  The corresponding global parameter is
TimeForReorderTone.
'Enable Voice Mail Delay'
enable-voice-mail-delay
[TelProfile_
EnableVoiceMailDelay]
Enables and disables voice mail services.
â–  [0] Disable
â–  [1] Enable (default)
The parameter is useful if you want to disable voice mail
services per Trunk Group to eliminate the phenomenon of
call delay on Trunks that do not implement voice mail when
voice mail is configured using the global parameter,
VoiceMailInterface.
'Swap Tel To IP Phone
Numbers'
swap-teltoip-phone-
numbers
[TelProfile_
SwapTelToIpPhoneNumbers]
Enables the device to swap the calling and called numbers
received from the Tel side (for Tel-to-IP calls). The SIP
INVITE message contains the swapped numbers.
â–  [0] Disable (default)
â–  [1] Enable
Note: The corresponding global parameter is
SwapTEl2IPCalled&CallingNumbers.
'IP-to-Tel Cut-Through Call
Mode'
ip2tel-cutthrough_call_
behavior
[TelProfile_
IP2TelCutThroughCallBehavior]
Enables the Cut-Through feature, which allows phones
connected to the device’s FXS ports to automatically
receive IP calls (if there is no other currently active call)
even when in off-hook state (and no call is currently active).
â–  [0] Disable = Calls can only be received in on-hook
state.
- 448 -

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes E-SBC and is the answer not in the manual?

AudioCodes E-SBC Specifications

General IconGeneral
BrandAudioCodes
ModelE-SBC
CategoryGateway
LanguageEnglish

Related product manuals