EasyManua.ls Logo

AudioCodes E-SBC - Page 573

AudioCodes E-SBC
1414 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER23 Digital PSTN
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
[128] SEND USER CONNECT ACK = The Connect
ACK message is sent in response to received Q.931
Connect; otherwise, the Connect ACK is not sent.
Note: This option is applicable only to Euro ISDN User
side outgoing calls.
[512] EXPLICIT INTERFACE ID = Enables configuration
of T1 NFAS Interface ID (refer to the parameter
ISDNNFASInterfaceID_x).
Note: This value is applicable only to 4/5ESS, DMS, NI-2
and HKT variants.
[2048] ALWAYS EXPLICIT = Always set the Channel
Identification IE to explicit Interface ID, even if the B-
channel is on the same trunk as the D-channel.
Note: This value is applicable only to 4/5ESS, DMS and
NI-2 variants.
[32768] ACCEPT MU LAW =Mu-Law is also accepted in
ETSI.
[65536] EXPLICIT PRES SCREENING = The calling
party number (octet 3a) is always present even when
presentation and screening are at their default.
Note: This option is applicable only to ETSI, NI-2, and
5ESS.
[131072] STATUS INCOMPATIBLE STATE = Clears
the call on receipt of Q.931 Status with incompatible state.
Otherwise, no action is taken (default).
[262144] STATUS ERROR CAUSE = Clear call on
receipt of Status according to cause value.
[524288] ACCEPT A LAW =A-Law is also accepted in
5ESS.
[2097152] RESTART INDICATION = Upon receipt of a
Restart message, acEV_PSTN_RESTART_CONFIRM is
generated.
[4194304] FORCED RESTART = On data link
(re)initialization, send RESTART if there is no call.
[67108864] NS ACCEPT ANY CAUSE = Accept any
Q.850 Cause IE from ISDN.
Note: This option is applicable only to Euro ISDN.
[134217728] NS_BRI_DL_ALWAYS_UP (0x08000000)
= By default, the BRI D-channel goes down if there are no
active calls. If this option is configured, the BRI D-channel
is always up and synchronized.
[536870912] = Alcatel coding for redirect number and
display name is accepted by the device.
Note: This option is applicable only to QSIG (and relevant
for specific Alcatel PBXs such as OXE).
- 535 -

Table of Contents

Related product manuals