CHAPTER6 Web-Based Management
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
â– Valid = User can log in to the Web interface as normal.
â– Failed Login = The state is automatically set for users that
exceed a user-defined number of failed login attempts, set by
the 'Deny Access on Fail Count' parameter (see Configuring
Web Session and Access Settings). These users can log in
only after a user-defined timeout configured by the 'Block
Duration' parameter (see below) or if their status is changed
(to New or Valid) by a Security Administrator or Master.
â– Inactivity = The state is automatically set for users that have
not accessed the Web interface for a user-defined number of
days, set by the 'User Inactivity Timer' (see Configuring Web
Session and Access Settings). These users can only log in to
the Web interface if their status is changed (to New or Valid)
by a System Administrator or Master.
Note:
â– The Inactivity status is applicable only to Administrator and
Monitor users; Security Administrator and Master users can
be inactive indefinitely.
â– For security, it is recommended to set the status of a newly
added user to New in order to enforce password change.
Security
'Password Age'
password-age
[WebUsers_
PwAgeInterval]
Defines the duration (in days) of the validity of the password.
When the duration elapses (i.e., password expires), when
attempting to log in, the user is prompted to change the password
(shown below), and then log in with the new password; otherwise,
access to the Web interface is blocked.
The valid value is 0 to 10000, where 0 means that the password is
always valid. The default is 90.
- 46 -
To Next Page
Loading...
Need help?
General
