CHAPTER45 License Key
Mediant 1000 Gateway & E-SBC | User's Manual
The License Key installation process includes a device reset and is therefore, traffic-
affecting. To minimize the disruption of current calls, it is recommended to perform this
procedure during periods of low traffic.
➢ To install a License Key file for standalone devices through Web interface:
1. Open the License Key page (see Viewing the License Key).
2. Back up the currently installed License Key, as a precaution. If the new License Key does not
comply with your requirements, you can re-load this backed-up License Key to restore the
device's original capabilities. For backing up the License Key, see Backing up the License
Key.
3. Click the Load By File button, navigate to the License Key file on your computer, and then
select the file to load to the device; the Apply New License Key button appears. The License
Key page uses color-coded icons to indicate the changes between the previous License Key
and the newly loaded License Key (for more information, see Installing License Key through
Web Interface).
If want to cancel installation, reset the device without a save to flash. For more
information, see Resetting the Device.
4. Click Apply New License Key; the following message box appears:
5. Click Reset; the device begins to save the file to flash memory with a reset and the following
progress message box appears:
When installation completes, the following message box appears:
- 875 -
To Next Page
Loading...
Need help?
General
