ATM-TRK (Circuit Emulation Service Circuit Pack)
Issue 4 May 2002
10-251 555-233-123
1394 ABORT ATM-TRK circuit pack out of service
Run ATM Board Reset Test #1256.
2000 ABORT Request timed out.
Retry the command up to 3 times at 1-minute intervals.
2060 ABORT Packet-bus link has failed.
Retry the command up to 3 times at 1-minute intervals.
If the test continues to abort, run display errors, and perform the
repairs associated with PKT-INT errors.
2100 ABORT Could not allocate the necessary system resources to run this
test.
2500 ABORT Internal system error
Retry the command up to 3 times at 1-minute intervals.
1 FAIL Test tone not detected over the looparound; packet-path test
aborted.
Test the active tone clock on the port network, and verify that a
tone is reaching the ATM-TRK circuit pack. If not, correct the
condition.
Run test board UUCSS long.
If the test continues to fail, replace the ATM-TRK circuit pack or
transceiver.
Rerun test board UUCSS long.
2 FAIL TN1655 Packet Interface circuit pack could not detect the correct
data packet.
Test the TN1655 Packet Interface circuit pack to verify that it is
functioning properly. If not, correct the condition.
Run display errors, and perform the repairs associated with DS1
CONV-BD errors, if applicable.
Run display alarms, and perform the repairs associated with
DS1 CONV-BD alarms, if applicable.
Run test board UUCSS long.
If this test continues to fail, replace the ATM-TRK circuit pack.
Run test board UUCSS long.
Table 10-102. ATM Board Framer Looparound Test (#1260) — Continued
Error
Code
Test
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
