BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI
ISDN-BRI Port)
Issue 4 May 2002
10-289 555-233-123
Table 10-115. TEST #624 Layer 1 Transmission Error Counter Test
Error
Code
Tes t
Result Description/Recommendation
2000 ABORT Response to the test was not received from the circuit pack
within the allowable time period.
1. If the test aborts repeatedly a maximum of five times,
reset the circuit pack via the busyout board PCSS and
reset board PCSS commands.
2. If the test aborts again, replace the circuit pack.
2012 ABORT Internal System Error.
2100 ABORT Could not allocate necessary system resources to run test.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
value FAIL The BRI-LINE circuit pack is still detecting errors of this
type. The Error Code field contains the value of this
counter.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
2. If the test continues to fail, review the results of other
tests in the Long Test Sequence. Pay particular
attention to the results of the Level 1 Status Inquiry
test. Follow repair procedures for any of the executed
tests if they fail. Otherwise, go to the next step.
3. If the tests for the endpoints or adjunct pass and the
Layer 1 Transmission Error Counter Test continues to
fail, check the wiring to the endpoints or adjunct. If the
wiring appears to be fine, escalate the problem.
PASS The Layer 1 Transmission error counter was read correctly
and has a value of 0.
Continued on next page
To Next Page
Loading...
