CLAN-BD (Control LAN Circuit Pack)
Issue 4 May 2002
10-405 555-233-123
Invalid LAPD Frame Error Counter Test (#597)
This test is non-destructive.
CLAN detects invalid frames when it receives
■ a frame with a CRC error
■ an unrecognizable frame
■ a recognizable frame in an unexpected state
When the CLAN circuit pack detects an invalid LAPD frame, it increments the
Invalid LAPD Frame error counter. This test reads and clears the counter, and
verifies the repair of the problem.
Errors may indicate a
■ circuit pack problem
■ packet bus problem
■ problem with another circuit pack on the bus
Table 10-150. TEST #597 Invalid LAPD Frame Error Counter Test
Error
Code
Tes t
Result Description/Recommendation
2000 ABORT Did not receive circuit pack test response within the allowable
time period.
1. Retry command at 1-minute intervals, up to 5 times.
2. If the problem persists, reset the circuit pack (reset board
UUCSS).
3. If the problem persists, replace the circuit pack.
2100 ABORT Could not allocate the necessary system resources to run this
test.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 5 times.
2. If the problem persists, escalate the problem.
Continued on next page