System Backup
Issue 4 May 2002
5-21555-233-123
Type save announcements to save recorded announcements in the system on
the translation card.
NOTE:
A 10 MByte or larger translation card is required to save and restore
announcements.
The system takes about 10 minutes to complete this task. Because the terminal is
unavailable during this time, it is recommended that this command be used after
business hours. During this time period, the terminal cannot be used to administer
the system until the transfer is complete; however, all other terminals (if provided)
are allowed to perform administration procedures.
Type restore announcements to restore the recorded announcements from the
translation card back into system memory. The system takes about 22 minutes to
complete this task. After completing the task, the system performs an audit to
make sure that the announcements on the announcement circuit pack match the
announcements administered in the system.
The working copy of the announcements is stored on the announcement circuit
pack. A backup copy should be made on a 10 Mb or larger translation card. Use
the following procedure to make a backup Memory Card:
1. Remove the translation card from the Netcon circuit pack.
2. Insert the backup translation card into the Netcon circuit pack.
3. Enter the save translation command and press
Enter. This instructs the
system to take all translation information in memory and transfer it into the
translation card. The following display appears:
Screen 5-1. Save Translation — SPEA
4. Verify that the command successfully completes. If not, an error message
appears. In such a case, refer to the “Translation Card Errors” section.
5. If the system is equipped with a TN750 Announcement circuit pack, the
recorded announcements can be saved using save announcements.
Enter the command and press
Enter. The following screen appears:
save translation SPE A
SAVE TRANSLATION
Processor Command Completion Status Error Code
SPE_A Success 0
Command successfully completely
To Next Page
Loading...
