DIG-IP-STN (Digital IP Station)
Issue 4 May 2002
10-555 555-233-123
NOTE:
This nondestructive test runs due to in-line errors, during periodic and
schedule maintenance, and on demand.
Table 10-203. TEST #1373 Signaling Path PING Test
Error
Code
Tes t
Result Description/Recommendation
2100 ABORT Could not locate the necessary system resources to run this
test.
Retry the command at 1-minute intervals, up to 5 times.
Escalate if the problem persists.
2500 ABORT Internal system error
Retry the command at 1-minute intervals, up to 3 times.
Escalate if the problem persists.
1003 FAIL Ping to the destination failed.
Retry the command at 1-minute intervals, up to 3 times.
Investigate any C-LAN ethernet port errors.
1007 FAIL The system could not PING the registered endpoint via the
C-LAN.
Verify that at least one destination reachable through this port.
PING this destination (ping ip-address xxx.xxx.xxx.xxx).
If the PING to any destination is successful through this port, the
link is up.
If PING to all destinations fail, test the C-LAN port (test port
UUCSSpp short) and follow repair procedures for Session
Status Test (#1286) failures.
If only this station cannot be pinged:
Make sure the PC is up
Make sure the PC has a network connection (ethernet or dialup)
Check the ethernet cabling
PASS The system can successfully send IP packets to the registered
endpoint from the C-LAN.
Continued on next page
To Next Page
Loading...
