Avaya Definity SI - Page 136

Routine Maintenance Procedures
555-233-123
5-32 Issue 4 May 2002
Out-of-Service Time Slots To place the call:
1. Dial the Facility Test Call Feature Access Code (administered on the
Feature Access Codes screen), and listen for dial tone.
2. Dial port network number (1 for PPN or 2 or 3 for EPN), then dial ** and
listen for the following tones:
■ Confirmation Tone—Connection is made. Go to Step 3.
■ Reorder Tone—No time slots are out-of-service.
3. Repeat from Step 1 to alternate between out-of-service time slots on TDM
Bus A and B.
System Tone Test Call
The system tone test call connects the voice terminal user to a specific system
tone. To place the call:
1. Dial the Facility Test Call Feature Access Code (administered on the
Feature Access Codes screen), and listen for dial tone.
2. Dial port network number (1 for PPN or 2 or 3 for EPN), then dial
* followed
by the two-digit tone identification number listed in Table 5-5 on page 5-33.
3. Listen for the tone that was specified.
NOTE:
For a definition of Call Progress Tones see Avaya MultiVantage
Hardware Solutions Guide.