Maintenance Object Repair Procedures
555-233-123
10-664 Issue 4 May 2002
1950 ABORT Another loopback/span test is already executing on the DS1
board or the board is in a network requested loopback mode
(Line loopback or Payload loopback). The hardware error log will
indicate whether a Customer Loopback Jack Test, Far CSU
Loopback Test, or the One-Way Span Test is executing or if the
board is in line loopback or payload loopback mode. Only one
long-duration loopback/span test can be active at a given time.
Thus, if a loopback/span test is already active, that test must be
terminated via the test ds1-loop UUCSS end-loopback/span-test
command in order to execute this test.
ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals for a maximum of 5
times.
Table 10-244. TEST #1209 DS1 Board Loopback Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
