Maintenance Object Repair Procedures
555-233-123
10-690 Issue 4 May 2002
The list measurements ds1 summary command will display the length of time the
test ran (Test Duration field) and number of bit errors detected (Loopback/Span
Test Bit-Error Count field).
To restore the trunks or ports on the TN767E DS1 Interface circuit pack to the
in-service state, execute the release board command.
Table 10-251. TEST #1216 End Loopback/Span Test
Error
Code
Tes t
Result Description/Recommendation
ABORT Internal system error
1. Retry the test ds1-loop UUCSS end-loopback/span-test
command at 1-minute intervals a maximum of 5 times.
1005 ABORT End Loopback/Span Test cannot be executed in the current
configuration. To run this, the TN767E or later suffix DS1 must
be administered for 24-channel operation. The "Bit Rate" field on
the DS1 circuit pack administration form must be set to "1.544"
for 24-channel operation.
1015 ABORT Ports on the DS1 Interface circuit pack have not been busied out
to out-of-service.
1. Enter the busyout board UUCSS command to put all trunks
or ports of the DS1 Interface circuit pack into the
out-of-service state.
2. Retry the command.
ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals for a maximum of 5
times.
Continued on next page
To Next Page
Loading...
