E-DIG-STA (Emulated Digital Line)
Issue 4 May 2002
10-723555-233-123
E-DIG-ST maintenance monitors and tests ports on the TN800 MAPD circuit pack
and the hardware connected to those ports for lines administered as a digital
station. These include stations with an emulated digital voice terminal and stations
with an emulated digital voice terminal and a linked data module. Stand-alone
data modules and data adaptors in stand-alone mode are not supported by the
TN800 circuit pack. Circuit pack maintenance is covered by E-DIG-BD.
Hardware Error Log Entries and
Test to Clear Values
Notes:
a. Maintenance personnel has busied out the port in question. Make sure that
the port is released from busyout by using the release port PCSSpp
command.
b. The circuit pack has been removed or has been insane for more than 21
minutes. To clear the error, reinsert or replace the circuit pack.
Table 10-270. Digital Line Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
1 Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
0 Any Any Any test port PCSSpp sh r 1
18 (a) 0 busyout port PCSSpp WNG OFF rel port PCSSpp
130 (b) None WNG ON test port PCSSpp sh
1793 (c) Voice and Control Local
Loop Test (#13)
MIN/
WNG
2
2 Major alarms may be downgraded to Warning alarms based on the value used in the set options
command.
ON test port PCSSpp l r 3
2049 (d) NPE Crosstalk Test (#9) MIN/
WNG
2
ON test port PCSSpp l r 3
2305 (e) 32770 None
3840 (f) 40965 None
3841 (g) 41029 None
2304 (h) None
Continued on next page
To Next Page
Loading...
