Avaya Definity SI - Page 1534

Maintenance Object Repair Procedures
555-233-123
10-748 Issue 4 May 2002
Table 10-282. TEST #1282 Link Integrity Inquiry Test
Error
Code
Tes t
Result Description/Recommendation
1124 ABORT Ethernet link is not enabled.
1. Verify that the Ethernet link is enabled (status port
UUCSSpp, status link n, or display data-module).
2. If the link is not enabled, enable the link (change
data-module).
3. Repeat the test.
4. Escalate if the problem persists.
1125 ABORT Ethernet link not in service.
1. Verify whether Ethernet link is in service (status port
UUCSSpp or status link n).
2. If the Ethernet link is not in service, release the link (release
link n or release port UUCSSpp).
3. Repeat the test.
4. Escalate if the problem persists.
1959 ABORT Downlink message error.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Escalate if the problem persists.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Escalate if the problem persists.
2100 ABORT Could not locate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals, up to 5 times.
2. Escalate if the problem persists.
Continued on next page