Maintenance Object Repair Procedures
555-233-123
10-760 Issue 4 May 2002
7. If all tests pass and the alarm does not resolve, retest
(test tone UUCSS long clear).
8. If the test passes, terminate the repair process. If it fails,
replace the circuit pack at the customer’s convenience.
Follow the procedures in TONE-BD.
9. If the board is duplicated, switch to the standby side (set
tone).
10. Test the alarmed board (test tone UUCSS long). This
resets the board and is required to reload on-board RAM
associated with the TN2182’s DSPs.
11. If all tests pass and the alarm does not resolve, retest with
test tone UUCSS long clear.
12. If the test passes, terminate the repair process. If it fails,
replace the board. Follow the procedures in TONE-BD.
PASS The ETR Port has passed the sanity inquiry.
Table 10-286. TEST #43 Tone Detector Audit/Update Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
