EasyManua.ls Logo

Avaya Definity SI - Page 1575

Avaya Definity SI
2968 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EXP-INTF (Expansion Interface Circuit Pack)
Issue 4 May 2002
10-789555-233-123
1002 ABORT The system could not allocate time slots for the test. The system
may be under heavy traffic conditions or it may have time slots
out-of-service due to TDM-BUS errors. Refer to TDM-BUS
(TDM Bus) Maintenance documentation to diagnose any active
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling
heavy traffic, repeat test at 1-minute intervals a maximum of
5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors
present or some Tone Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer to
TTR-LEV (TTR Level) Maintenance documentation. Even if
there are no TTR-LEV errors, there still may not be a Tone
Detector available on the network that contains the circuit
pack being tested. Verify that there is at least one Tone
Detector on this network. If there is not at least one Tone
Detector, this test always aborts for this Expansion Interface
circuit pack. This does not harm the system in any way.
NOTE:
G3 systems require that Tone Detector circuit packs
(TN768) must be of vintage "B" or newer. If older Tone
Detector circuit packs are installed in the system, this test
well always abort with this abort code.
2. Look for TONE-PT errors in the Hardware Error Log. If
present, refer to TONE-PT (Tone Generator) Maintenance
documentation.
3. If neither condition exists, retry the test at 1-minute intervals
a maximum of 5 times.
1033 ABORT The test cannot run because either one or both of the Expansion
Interface circuit packs on this link are busied out or an
Expansion Interface circuit pack is not present on the opposite
end of the fiber.
1. If Expansion Interface is busied out, issue the release
board PCSS command.
2. Examine results of Tests #237 and #238.
Table 10-292. TEST #241 Expansion Interface 2-Way Transmission Test Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page

Table of Contents

Related product manuals