Avaya Definity SI - Page 1586

Maintenance Object Repair Procedures
555-233-123
10-800 Issue 4 May 2002
Table 10-295. TEST #336 Expansion Interface Reset Test
Error
Code
Te s t
Result Description/Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5
times.
4 ABORT Could not reset EPN Expansion Interface circuit pack over
optical fiber since PPN Expansion Interface circuit pack on
opposite end of fiber is not inserted.
1. Insert opposite Expansion Interface circuit pack and
perform reset again.
1015 ABORT The system does not allow this test to be run because the
Expansion Interface circuit pack has not been busied out.
1. Busyout the Expansion Interface circuit pack. Repeat the
reset board PCSS command.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
9999 ABORT Expansion Interface circuit pack reset successfully. Could not
perform initialization test results query because link to EPN is
not up.
1. Execute release board PCSS. Wait one minute. Issue the
display error command. If you see Error Type 2049
logged against this Expansion Interface circuit pack, then
the Expansion Interface Reset Test has failed with an error
code equal to the aux data of this entry. Otherwise, the
initialization tests have passed.
12000 ABORT Expansion Interface circuit pack reset successfully. Response
to the initialization test results query was not received within
the allowable time period.
12100 ABORT Expansion Interface circuit pack reset successfully. System
resources required to run initialization test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Continued on next page