FL-DATA (Flash Data Consistency)
Issue 4 May 2002
10-831555-233-123
35534 ABORT Could not allocate the (active or standby) memory card
drive because another memory card operation was in
progress.
1. Wait 10 minutes, and retry the command.
35535 ABORT Could not access the (active or standby) memory card.
1. The memory card may be damaged or missing.
Resolve all problems with all memory card tests in the
Long Test Sequence for both memory cards.
2. Repeat the test.
1 FAIL The standby translations are out-of-date. The translations
on the Standby SPE (memory card) are older than those
on the Active SPE (memory card).
2 FAIL The Active SPE translations are out-of-date.
1. Issue save translations command. If the translation
save passes on both SPEs, go to Step 2.
2. Run test card-mem long again to resolve the alarms.
4 FAIL The load vintages are different in both SPEs.
1. Determine the desired software release by issuing the
list configuration software long command. Obtain
the memory card of the same software release. Follow
the upgrade software procedure to upgrade the
out-of-date SPE.
2. Run test card-mem long again to resolve alarms.
5 FAIL The load vintages and translations are different in both
SPEs. The Active SPE has the most current translations.
1. Follow the procedures for Error Code 4.
6 FAIL The load vintages and translations are different in both
SPEs. The Standby SPE has the most current translations.
1. Follow the procedures for Error Code 4.
2. Issue save translations. If the translation save
passes on both SPEs, proceed to Step 3.
3. Run test card-mem long again to resolve alarms.
Table 10-303. TEST #421 Flash Data Consistency Check Test — Continued
Error Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
