FW-DWNLD (Firmware Download)
Issue 4 May 2002
10-853555-233-123
5. If you are self-downloading to a TN2501AP (VAL) circuit pack, reseat the
pack:
!
CAUTION:
Ensure that both the top green and top amber LEDs are out.
a. Release the latch handle to free the circuit pack from the carrier.
b. Pull the circuit pack out approximately 1-2 inches (2.54 to 5.08 cm.).
c. Re-insert the circuit pack into the carrier.
d. Close the latch securely.
Aborting a firmware download
If you need to abort a scheduled (pending) firmware download:
1. Type disable firmware download and press Enter.
This command
■ Continues to download the firmware image file to circuit pack in
progress.
■ Aborts the remainder of the download schedule.
■ Clears the contents of the Firmware Download screen (Screen
10-8).
Remote download
This procedure allows you to update up to 50 target circuit packs of the same type
using a new firmware image file distributed from a TN799C/DP (C-LAN) source
circuit pack. This procedure updates these target circuit packs:
■ UDS1 (TN464GP, TN2464BP, and TN2313AP)
■ Maintenance/Test (TN771DP)
■ IP Media Processor (TN2302AP)
Preparation
See ‘‘Hardware/software requirements’’.
To Next Page
Loading...
