H323-SGRP (H.323 Signaling Group)
Issue 4 May 2002
10-875555-233-123
Table 10-315. TEST #1386 CLAN Ethernet Status Test
Error
Code
Tes t
Result Description/Recommendation
1125 ABORT Ethernet Link is not in service.
1. Check if the ethernet link is in-service or not. If the link
is not in service, release the link using release link n
or the release port UUCSSpp command and repeat
the test. This is a normal abort.
2. If the test continues to abort after following the repair
procedures, escalate the problem.
2000 ABORT Response to the test was not received from the CLAN TN799
circuit pack within the allowable time period.
1. If this result occurs repeatedly, attempt to reset the
circuit pack if the other ports on the board are not in
use (Yellow LED is off). Reset the circuit pack by
issuing the busyout board UUCSS, reset board
UUCSS, and release board UUCSS commands.
2. If this result occurs again, replace the circuit pack.
2100 ABORT The necessary system resources to execute the test could not
be allocated.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum
of 3 times
FAIL The CLAN ethernet port corresponding to the near-end address
of the SIG-GRP that is OOS has failed. All sessions are down.
1. Execute test port UUCSSpp long and verify the
result of the H.323 Signaling Group Ping Test (#1387).
If the test continues to fail, escalate the problem. If the
test passes wait for the sessions to come up.
PASS The CLAN ethernet port corresponding to the near-end address
of the SIG-GRP that is in-service has passed this test. All
sessions on the ethernet link are up.
Continued on next page
To Next Page
Loading...
