HYB-LINE (Hybrid Line)
Issue 4 May 2002
10-909555-233-123
PASS Hybrid Line Audits Test passed.
1. Although this test always return a PASS result, it may
enter Error Types 257 or 513 into the Error Log. To
determine if there are any problems that don’t show up in
the test result, look for these error types in the Error Log.
2. If these errors appear in the Error Log, or if user
complaints still exist, investigate by using other circuit
pack tests, and by examining the station, wiring, and
connections.
0NO
BOARD
The test could not relate the internal ID to the port (no board).
This could be due to incorrect translations, no board is
inserted, an incorrect board is inserted, or an insane board is
inserted.
1. Check to ensure that the board translations are correct.
Use list config, and resolve any problems that are found.
2. If the board was found to be correctly inserted in step 1,
issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should
re-establish the linkage between the internal ID and the
port. If this is not the case, dispatch to check to ensure
that there is a valid board inserted.
Table 10-330. TEST #61 Hybrid Line Audits Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
