Maintenance Object Repair Procedures
555-233-123
10-918 Issue 4 May 2002
Demand Reset Test (#704)
This test is destructive.
This test executes a comprehensive set of diagnostic tests. The test aborts if the
I/O Processor is in the in-service state. The test takes the I/O Processor
out-of-service if background maintenance has reset it 3 times by within the last 15
minutes.
Table 10-333. TEST #703 Demand Reset Test
Error
Code
Tes t
Result Description/Recommendation
1362 ABORT I/O Processor is in-service.
1. Determine status of the I/O Processor (display alarms).
2. If the I/O Processor status is OUT, retry the command.
2000 ABORT Response to the test was not received within the allowable time
period.
1. Retry the command at 1-minute intervals, up to 3 times.
Any FAIL Test failed.
1. Retry the command.
2. If the problem persists, replace the TN2401/TN794 NetPkt
circuit pack.
PASS The I/O Processor diagnostic tests passed.
Continued on next page
To Next Page
Loading...
