Maintenance Object Repair Procedures
555-233-123
10-926 Issue 4 May 2002
Table 10-337. TEST #53 SAKI Sanity Test
Error
Code
Tes t
Result Description/Recommendation
None ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
1015 ABORT Port is not out-of-service.
1. Busy out the circuit pack.
2. Execute command again.
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
2803 ABORT It is necessary to reset the board.
1. Use the change ip-interfaces form to disable the
Media Processor IP interface.
2. Execute the command again.
1 FAIL The circuit pack failed to reset.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
2,
2000
FAIL The circuit pack failed to restart.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
PASS The circuit pack initializes correctly.
1. Run the short test sequence.
Any NO
BOARD
This is normal if the test is being done when (a) the board is not
physically in the system or (b) the system is booting up.
Otherwise, there is some inconsistency between the physical
configuration and the data kept in the system.
1. Verify that the board is physically in the system.
2. Verify that the system is not in a stage of booting up.
3. Retry the command at 1-minute intervals for a
maximum of 5 times.
Continued on next page
To Next Page
Loading...
