Maintenance Object Repair Procedures
555-233-123
10-932 Issue 4 May 2002
Table 10-341. TEST #1406 MP Diagnostic Test
Error
Code
Tes t
Result Description/Recommendation
2012 ABORT System error:
1. Retry the command at 1-minute intervals a maximum
of 5 times.
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
FAIL The MP Diagnostic test has failed for this TN2302 and the
board is in the OOS state.
1. Issue the busyout board UUCSS command.
2. Issue the reset board UUCSS command.
3. Issue the release board UUCSS command.
4. Issue the test board UUCSS long command.
If the board continues to fail replace the board.
8192 -
8328
FAIL The FPGA DSP test failed:
1. Issue the busyout board UUCSS command.
2. Issue the reset board UUCSS command.
3. Issue the release board UUCSS command.
4. Issue the test board UUCSS long command.
If the board continues to fail replace the board.
8448 -
8584
FAIL The TSI FPGS test failed:
1. Issue the busyout board UUCSS command.
2. Issue the reset board UUCSS command.
3. Issue the release board UUCSS command.
4. Issue the test board UUCSS long command.
If the board continues to fail replace the board.
12288
-
12424
FAIL The TSI DSP test failed:
1. Issue the busyout board UUCSS command.
2. Issue the reset board UUCSS command.
3. Issue the release board UUCSS command.
4. Issue the test board UUCSS long command.
If the board continues to fail replace the board.
Continued on next page
To Next Page
Loading...
