Maintenance Object Repair Procedures
555-233-123
10-974 Issue 4 May 2002
Figure 10-56. Secondary Signaling Link Hardware Check for PRI over PACCON
(Test #639)
Table 10-352. TEST #639 Secondary Signaling Link Hardware Check
Error
Code
Te s t
Result Description/Recommendation
ABORT Internal system error
1. Retry the command at 1minute intervals a maximum of 5
times.
1132 ABORT The Secondary D-channel is not administered for this
Signaling Group. This is a NORMAL ABORT. Only a Primary
D-channel must be administered for a Signaling Group.
4 FAIL There is a problem with the Processor Interface Link. No DS1
ISDN Trunk (B-channel) or Wideband PRI Endpoint calls can
be made until the problem is resolved.
1. Display the Communication-Interface Links Form via
display communication-interface to determine which
link is down (find the one that matches the DS1 Interface
circuit pack on which this ISDN-PRI Signaling Link Port
resides) and then refer to the PI-LINK Processor Interface
Link Maintenance documentation.
8 FAIL There is a problem with the DS1/UDS1 Interface circuit pack
or the ISDN-PRI Secondary Signaling channel (D-channel).
No ISDN Trunk (B-channel) or Wideband PRI Endpoint calls
can be made until the problem is resolved.
1. Refer to the DS1/UDS1 circuit pack and the ISDN-PRI
Signaling channel (ISDN-LNK/ISDN-PLK) Maintenance
documentation.
PASS The basic physical connectivity of the Signaling Group’s
Secondary D-channel is intact and functional. Try this test
repeatedly to ensure the link is up and to uncover any
transitory problems.
Continued on next page
Packet Bus
To far end
sw itch hard w a re
Processor
(TN786)
Packet
Control
Circuit
Pack
(TN778)
UDS1
In te rfa c e
Circuit
Pack
(TN464*)
*TN464 C or later
To Next Page
Loading...
