ISDN-TRK (DS1 ISDN Trunk)
Issue 4 May 2002
10-995555-233-123
1113 ABORT The signaling link has failed, so the system cannot send any
messages on behalf of this trunk.
1. Check the results of Test #255 (Signaling Link State
Check).
1114 ABORT The signaling link is in a transitional state.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1116 ABORT The trunk is not in a service state which is appropriate for
running the test. This test is only performed in the OOS/FE
state.
1117 ABORT A service state audit message is outstanding.
1. Wait two minutes and then try again.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1113 FAIL The signaling link has failed, so the system cannot send any
messages on behalf of this trunk.
1. Consult the procedures for ISDN-LNK (ISDN-PRI
Signaling Link Port) and PI-LINK (Processor Interface
Link).
FAIL Internal system error
1. Retry the command at 1-minute intervals a maximum of 5
times.
PASS Wait 4 minutes and then check the Error Log for any new
errors of type 3073. If there are none, then both sides of the
ISDN connection agree on the service state; the negotiation
succeeded. If there is a new 3073 error, then the negotiation
failed (the far-end switch twice failed to respond within 2
minutes). The switch will automatically retry every 15 minutes.
If the trunk was initially in-service, it is now placed in the
maintenance/far-end state. Incoming calls will be accepted,
but no outgoing calls can be originated. If an incoming call is
presented, another Service State Audit will be immediately
performed in an attempt to put the DS1 ISDN Trunk in the
proper state.
Table 10-361. TEST #256 Service State Audit Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
