Maintenance Object Repair Procedures
555-233-123
10-1002 Issue 4 May 2002
2067 ABORT The call has timed out, perhaps because of a lack of system
resources.
1. Follow the recommendations for ABORT code 2035.
2074 ABORT Bit and Block Error query failed.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort, there may be a serious
internal problem with Maintenance/Test Digital Port.
2075 ABORT Internal system error
1. Follow the recommendations for ABORT code 2012.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2104 ABORT Call dropped or could not be originated.
1. Make sure service is provisioned by the network.
2. Check the administration of the far-end test line extension
on the trunk group administration form.
3. Check the administration of the test call BCC (Bearer
Capability Class) on the trunk group administration form.
4. Check the reason for termination with status
isdn-testcall.
5. For further instructions see “Troubleshooting ISDN-PRI
Test Call Problems” in Chapter 5, ‘‘Routine Maintenance
Procedures’’.
6. Try the test again.
2201
2202
2203
2204
2205
ABORT Internal system error
1. Follow the recommendations for ABORT code 2012.
2206 ABORT Could not allocate the necessary system resources to run this
test.
1. Follow the recommendations for ABORT code 2100.
2208 ABORT Internal system error
1. Follow the recommendations for ABORT code 2012.
Table 10-363. TEST #258 ISDN TEST Call — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
