MAPD-BD (MAPD Interface Circuit Pack TN802)
Issue 4 May 2002
10-1047555-233-123
4. At the command prompt, type ping 10.32.64.96 (the IP address of the
internal Motorola MPC860 processor) and press
Enter.
■ If configured correctly, the system displays:
Reply from nnn.nn.nn.nn: bytes=32 time <##ms
TTL=###
■ If there is no reply:
— Check that the internal cables on the TN802 circuit pack
(Notes 4 and 6 in Figure 10-67 on page 10-1049) are not
loose.
— Replace the circuit pack.
5. Ping the gateway: at the command prompt, type ping XX.XXX.XXX.XXX
(the IP address of the gateway) and press
Enter.
6. When finished, at the command prompt type exit and press
Enter.
To Next Page
Loading...
