Maintenance Object Repair Procedures
555-233-123
10-1062 Issue 4 May 2002
SAKI Sanity Test (#53)
This test is destructive.
This test resets the circuit pack. The test is highly destructive and can only be
initiated by a system technician-demanded reset board UUCSS command.
Table 10-387. TEST #53 SAKI Sanity Test
Error
Code
Te s t
Result Description/Recommendation
None ABORT System resources required for this test are not available.
1. Retry reset board at 1-minute intervals a maximum of 5
times.
1015 ABORT Port is not out-of-service.
1. Busyout the circuit pack (busyout board UUCSS).
2. Execute reset board.
2100 ABORT System resources required for this test are not available.
1. Retry reset board at 1-minute intervals a maximum of 5
times.
1 FAIL The circuit pack failed to reset.
2 FAIL The circuit pack failed to restart.
1. Execute the reset board command again.
2. If the problem persists, replace the circuit pack.
Continued on next page
To Next Page
Loading...
