MODEM-PT (Modem Pool Port)
Issue 4 May 2002
10-1103555-233-123
1002 ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or it may have
time slots out-of-service due to TDM-BUS errors. Refer to
TDM-BUS (TDM Bus) Maintenance documentation to
diagnose any active TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not
handling heavy traffic, repeat the test at 1-minute
intervals a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test.
The system may be oversized for the number of Tone
Detectors present or some Tone Detectors may be
out-of-service.
1. Look for TTR-LEV errors in the Hardware Error Log. If
present, refer to TTR-LEV (TTR Level) Maintenance
documentation.
2. Look for TONE-PT errors in the Hardware Error Log. If
present, refer to TONE-PT (Tone Generator)
Maintenance documentation.
3. If neither condition exists, retry the test at 1-minute
intervals a maximum of 5 times.
1004 ABORT The port has been seized by a user for a valid call.
Determine whether the port is available for testing.
1. Retry the command at 1-minute intervals a maximum of
5 times.
1020 ABORT The test did not run due to a previously existing error on the
specific port or because of a more general circuit pack error.
1. Examine the Hardware Error Log for existing errors
against this port or the circuit pack, and attempt to
diagnose the previously existing errors.
2000 ABORT A response to the test request was not received within the
allowable time period.
1. Retry the command at 1-minute intervals a maximum of
5 times.
2100 ABORT System resources required for this test are not available.
1. Retry the command at one-minute intervals a maximum
of 5 times.
Table 10-415. TEST #96 Modem Pool NPE Crosstalk Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
