Maintenance Object Repair Procedures
555-233-123
10-1106 Issue 4 May 2002
1003 ABORT The system could not allocate a tone receiver for the test.
The system may be oversized for the number of Tone
Detectors present or some Tone Detectors may be
out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present,
refer to TTR-LEV (TTR level) Maintenance
documentation.
2. Look for TONE-PT errors in the Error Log. If present,
refer to TONE-PT (Tone generator) Maintenance
documentation.
3. If neither condition exists, retry the test at one-minute
intervals a maximum of 5 times.
1004 ABORT The port has been seized by a user for a valid call.
Determine whether the port is available for testing.
1. Retry the command at one-minute intervals a
maximum of 5 times.
1020 ABORT The test did not run due to a previously existing error on the
specific port or because of a more general circuit pack
error.
1. Examine the Hardware Error Log for existing errors
against this port or the circuit pack, and attempt to
diagnose the previously existing errors.
2000 ABORT The response to the test request was not received within
the allowable time period.
2012 ABORT Internal System Error.
2100 ABORT System resources required for this test are not available.
2103 ABORT The system could not make the conference connection for
the test.
1. Retry the command at one-minute intervals a
maximum of 5 times.
Table 10-416. TEST #97 Modem Pool Conference Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
