Maintenance Object Repair Procedures
555-233-123
10-1120 Issue 4 May 2002
Table 10-421. TEST #6 TSI Crosstalk Test
Error
Code
Tes t
Result Description/Recommendation
ABORT Internal system error. This is an abnormal abort.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1002 ABORT The system could not allocate time slots for the test, the traffic
load on the system is very high, or the time slots are
out-of-service due to TDM-BUS errors. Refer to “TDM-BUS” to
diagnose any active TDM Bus errors.
1. If the system has no TDM-BUS errors and is not handling
heavy traffic, repeat the test at 1-minute intervals a maximum
of 5 times.
1003 ABORT The system could not allocate a tone detector for the test. The
system is oversized for the number of tone detectors present, or
some tone detectors are out-of-service.
1. Resolve any “TTR-LEV” errors in the Error Log.
2. Resolve any “TONE-PT” errors in the Error Log.
3. If neither condition exists, retry the test at 1-minute intervals
a maximum of 5 times.
2000 ABORT Response to the test was not received from the MMI-BD circuit
pack within the allowable time period.
1. If this result occurs repeatedly, attempt to reset the circuit
pack if the other ports are not in use. Reset the circuit pack
by issuing the busyout board PCSS, reset board PCSS,
followed by the release board PCSS commands.
2. If this result occurs again, replace the circuit pack.
2012 ABORT Internal system error. This is an abnormal abort.
2100 ABORT Could not allocate the necessary resources to run this test. This
is an abnormal abort.
1. Retry the command at 1-minute intervals a maximum of 5
times.
FAIL The TSI was found to be transmitting in error. This causes noisy
and unreliable connections.
1. Replace the circuit pack.
PASS The TSI is correctly using its allocated time slots.
Continued on next page
To Next Page
Loading...
