Maintenance Object Repair Procedures
555-233-123
10-1162 Issue 4 May 2002
Table 10-439. TEST #567 Packet Bus Port Health Inquiry Test
Error
Code
Te s t
Result Description/Recommendation
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT System resources necessary to run this test are not available.
2500 ABORT An internal operation failed; the test could not be completed.
1. Retry the command at one-minute intervals a maximum of 5
times.
2059 FAIL The Maintenance/Test Packet Bus Port has reported a failure of
the on-board self-test.
2060 FAIL The Maintenance/Test Packet Bus Port has reported an invalid
state for the Packet Bus.
2061 FAIL The SPE cannot communicate with the Maintenance/Test
Packet Bus Port, but is able to communicate with the
Maintenance/Test Circuit Pack.
1. Retry the command.
2. If the test continues to fail, replace the Maintenance/Test
circuit pack and retry the command.
3. If the test continues to fail, refer to PKT-BUS Maintenance
documentation to determine if the M/T-PKT failure is being
caused by a Packet Bus fault.
PASS The Maintenance/Test Packet Bus Port Packet Bus fault
detection capability is operating correctly.
Continued on next page
To Next Page
Loading...
