Maintenance Object Repair Procedures
555-233-123
10-1172 Issue 4 May 2002
Table 10-442. TEST #7 Conference Circuit Test
Error
Code
Tes t
Result Description/Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at one-minute intervals a
maximum of 5 times.
1000 ABORT System resources required to run this test are not
available. The port may be in use on a valid call. Use the
status station or status trunk command to determine
when the port is available for testing.
1. Retry the command at one-minute intervals a
maximum of 5 times.
2. If the test continues to abort, and the port is not in use,
escalate the problem.
1002 ABORT The test was aborted because the system could not
allocate time slots for the test. The system might be under
heavy traffic conditions, or it might have time slots out of
service due to TDM-BUS errors. (The status health
command may be used to determine whether the system
is experiencing heavy traffic.) Refer to the TDM-BUS (TDM
bus) Maintenance documentation to diagnose any active
TDM-BUS errors.
1. If the system has no TDM-BUS errors, is not handling
heavy traffic, and the port status is idle, retry the
command at 1-minute intervals for a maximum of 5
times.
1003 ABORT The system could not allocate a tone receiver for the test.
The system may be oversized for the number of tone
detectors present or some of the tone detectors may be
out of service. Issue the list measurements
tone-receiver command to display basic information about
the system’s tone receivers.
1. Look for TTR-LEV errors in the error log. If present,
refer to the TTR-LEV Maintenance documentation.
2. Look for TONE-PT errors in the error log. If present,
refer to the TONE-PT Maintenance documentation.
3. If neither condition exists, retry the test at 1-minute
intervals for a maximum of 5 times.
Continued on next page
To Next Page
Loading...
