Maintenance Object Repair Procedures
555-233-123
10-1252 Issue 4 May 2002
1029
1030
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
2025
2051
ABORT Refer to the STBY-SPE Maintenance documentation for a
description of these error codes.
12 FAIL Processor Interface circuit pack reported that the Loop Around
Test failed.
1. Retry the test. If the test continues to fail, try resetting the
circuit pack via the reset interface PCS command.
2. If test continues to fail, replace the TN765 circuit pack. Refer
to Chapter 6, ‘‘Reliability Systems: A Maintenance Aid’’ for
instructions on how to replace an SPE complex circuit pack.
PASS TN765 Processor Interface Circuit Pack Loop Around Test
passed. The hardware associated with this port is functioning
properly.
Table 10-468. TEST #404 Standby Processor Interface Port Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
