PR-MEM (TN2404/TN790 RISC Memory)
Issue 4 May 2002
10-1403555-233-123
b. This test is run only on the Standby SPE in a High or Critical Reliability
system. On other systems or on the Active SPE, the test is run only via a
reset system 4 command or a reset system 5 command.
c. Refer to PR-MAINT (MainTenance Processor) Maintenance documentation
for a description of these tests.
Read All Memory Test (#85)
This test is a nondestructive test. The test reads every memory location in
memory. A failure of this test indicates a DRAM failure in the Processor
circuit pack. DRAM is replaceable and installed in 3 Single Inline Memory
Module (SIMM) sockets on this circuit pack. Replacement of these SIMMs
is described in the “Circuit Pack Replacement Procedure” section.
Table 10-523. TEST #85 Read All Memory Test
Error Code
Te s t
Result Description/Recommendation
100 ABORT The requested test did not complete within the allowable
time period.
1. Retry the command.
1029 2014
2015 2016
2017 2018
2020 2022
2024 2025
2051
ABORT Refer to STBY-SPE Maintenance documentation for a
description of these error codes.
2500 ABORT Internal system error
1. Retry the command.
Continued on next page
To Next Page
Loading...
