PROCR (TN2404/TN790 RISC Processor Circuit Pack)
Issue 4 May 2002
10-1427555-233-123
Notes:
a. Refer to “PR-MEM” for a description of these tests.
b. There are Functional Memory Test errors against the Processor circuit
pack. This test is run only on the Standby SPE in a high or critical reliability
system. On other systems or on the Active SPE, the test is run only via a
reset system 4 command or a reset system 5 command.
c. Refer to “PR-MAINT” for a description of these tests.
Processor BOOTPROM Checksum Test (#80)
This test is a nondestructive test. This test computes the checksum of the
Processor’s bootstrap BOOTPROM. A failure indicates the BOOTPROM is
corrupt.
Table 10-538. Test #80 Processor BOOTPROM Checksum Test
Error
Code
Te s t
Result Description/Recommendation
100 ABORT The test did not complete within the allowable time period.
1. Retry the command.
1029 2014
2015 2016
2017 2018
2020 2022
2024 2025
2051
ABORT Refer to STBY-SPE Maintenance documentation for a
description of these error codes.
2500 ABORT Internal system error
1. Retry the command.
FAIL The computed checksum did not match the BOOTPROM
checksum. The system may not continue to operate correctly.
The system may fail at some future date when the corrupted
area the bootstrap BOOTPROM is accessed.
1. Replace the Processor circuit pack.
NOTE:
If you replace the Processor circuit pack, you need
to obtain a new license file.
PASS The computed checksum matched the BOOTPROM checksum.
This part of the Processor will continue to operate normally.
Continued on next page
To Next Page
Loading...
