Maintenance Object Repair Procedures
555-233-123
10-1456 Issue 4 May 2002
6 ABORT This port may have been busied out by a system technician.
1. Look in the Error Log for Error Type 18 (port busied
out) for this port. If this error is present, release the
port using the release station command.
2. Make sure that the terminal is connected.
3. Retry the command at 1-minute intervals a maximum
of 5 times.
1000 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
1392 ABORT This port is currently a TTI port and the test will not execute on it.
1. Verify that the port is a TTI port using either the
display port command (the display shows that the
port is a TTI port) or the list config command (the
display shows a t for the port).
2. If either list config or display port indicate that the
port is not a TTI port, escalate the problem. If both
commands indicate that the port is a TTI port, the
abort is correct, and no action is necessary.
2000 ABORT Response to the test was not received in the allowable time
period.
FAIL Internal system error
1. Retry the command at 1-minute intervals a maximum
of 5 times.
PASS Station Audits passed. This Digital Port circuit pack is functioning
properly.
1. If complaints persist, investigate by using other port
tests, and by examining the station, wiring, and
connections.
Table 10-552. TEST #17 Station (Digital) Audits Test — Continued
Error
Code
Te st
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
