EasyManua.ls Logo

Avaya Definity SI - Page 2258

Avaya Definity SI
2968 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance Object Repair Procedures
555-233-123
10-1472 Issue 4 May 2002
Table 10-556. TEST #6 NPE Crosstalk Test
Error
Code
Te s t
Result Description/Recommendation
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at one-minute intervals a maximum
of 5 times.
1000 ABORT System resources required to run this test are not available.
The port may be busy with a valid call and therefore
unavailable for certain tests. You must wait until the port is
idle (yellow LED if off) before retesting.
1. If the port is idle, retry the command at one-minute
intervals a maximum of 5 times.
1001 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at one-minute intervals a maximum
of 5 times.
1002 ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or it may have
time slots out-of-service due to TDM-BUS errors. Refer to
TDM-BUS (TDM Bus) Maintenance documentation to
diagnose any Active TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling
heavy traffic, repeat test at one-minute intervals a
maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors
present or some Tone Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer
to TTR-LEV (TTR Level) Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer
to TONE-PT (Tone Generator) Maintenance
documentation.
3. If neither condition exists, retry the test at one-minute
intervals a maximum of 5 times.
1004 ABORT The port was seized by a valid call during the test and the test
has been aborted. You must wait until the port is idle (yellow
LED if off) before retesting.
1. Retry the command at one-minute intervals a maximum
of 5 times.
2. If the test continues to abort and the port is not in use,
escalate the problem.
Continued on next page

Table of Contents

Related product manuals