SW-CTL (Switch Control)
Issue 4 May 2002
10-1585 555-233-123
Table 10-587. TEST #325 Switch Control Destructive EPN
Maintenance Board Interface Test
Error
Code
Te s t
Result Description/Recommendation
1005 ABORT The system does not contain an EPN so this test is not
executed.
32500 ABORT Test disabled through software patch.
2013
32511
ABORT Could not allocate the system resources to run for this test.
2012
32513
32514
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5
times.
1029
2014
2015
2016
2017
2018
2020
2022
2024
2025
2051
ABORT Refer to STBY-SPE for a description of these error codes.
32515 FAIL This failure indicates that communications with the
Maintenance circuit pack in the EPN is probably not possible.
The EPN management terminal may not be usable.
1. Run the Long Test Sequence several times to make sure
the error is occurring consistently. Remember the Long
Test Sequence is destructive. Placing and receiving
calls is affected for several seconds.
2. Replace the NetPkt or Netcon circuit pack.
PASS The EPN Maintenance circuit pack interface between the
processor and the Switch Control is working correctly.
Continued on next page
To Next Page
Loading...
