TAPE (Tape Unit) [G3iV1.1-286]
Issue 4 May 2002
10-1631 555-233-123
Table 10-604. Table B. Tape Unit Aux Data Table
Digit
Aux Data/
Error Code (a) Explanation Strategy
0 0 Exact cause of error is not
determined.
1. Follow the instructions
provided in the ‘‘Tape
Maintenance and Repair
Procedures’’ section.
2. If this is the only error and
there is no alarm, ignore this
error.
1 1xxxx If the aux data is "10000," the
error is non-fatal.
Ignore the "10000" case.
Each of the last four digits of
the Aux Data "1xxxx" is a
non-zero value.
Follow the steps in the appropriate
aux data section.
2 2xxx The tape cartridge should be
replaced soon.
1. Follow the instructions
provided in the ‘‘Tape
Maintenance and Repair
Procedures’’ section.
3 3xx Cannot read or write at least
one block of data from the tape.
4 4x A problem was found reading
the Shared Memory.
5 5 Tape drive self-test failed.