TBRI-PT (TN2185 ISDN Trunk-Side BRI Port)
Issue 4 May 2002
10-1673 555-233-123
Table 10-614. TEST #618 BRI Port Local LAN Loop Around
Error
Code
Te s t
Result Description/Recommendation
1015 ABORT The port is not out-of-service.
1. Use status bri-port PCSSpp to determine the status of
the port.
2. If it is in use, wait until it is idle, and then use busyout
port PCSSpp to place it in the out-of-service state and
repeat this test.
!
CAUTION:
Since the busyout command is destructive,
execution of this command prior to the port being
idle causes all calls associated with the BRI port
to be torn down.
1139 ABORT The Packet Bus in the port network is out-of-service.
1. Follow the repair procedures for the Packet Bus.
2. Run test port long PCSSpp and verify the repair by
viewing the results of the BRI Port Local LAN
Looparound Test (#618).
1141 ABORT The PKT-CTRL is out-of-service.
1. Follow the repair procedures for the PKT-CTRL.
2. Run test port long PCSSpp and verify the repair by
viewing the results of the BRI Port Local LAN
Looparound Test (#618).
1144 ABORT The PPN Packet Bus is out-of-service.
1. Follow the repair procedures for the Packet Bus.
2. Run test port long PCSSpp and verify the repair by
viewing the results of the BRI Port Local LAN
Looparound Test (#618).
Continued on next page