Maintenance Object Repair Procedures
555-233-123
10-1706 Issue 4 May 2002
Procedure 3 (Destructive)
Reset the port network that contains the circuit pack that is in the reset state.
When a network is reset, two restart messages, one on the control channel of
each TDM Bus, are sent to each circuit pack on the network. Executing the reset
system L command (where L=2, 3, 4, or 5) resets all networks in the system. To
reset an EPN only, busyout all links to the EPN via the busyout board PCSS
command and then release them via the release board PCSS command.
!
WARNING:
The reset system command disrupts all calls in the system. Resetting the
EPN only disrupts all calls going to and originating from the EPN.
Procedure 4 (Destructive)
Execute the recycle carrier PC command where P is the Port Network Number of
the network containing the circuit pack and C is the designation of the carrier
containing the circuit pack.
!
WARNING:
This command removes power and returns power to the designated Medium
cabinet port carrier. Thus, any other circuit packs on this carrier is also
temporarily taken out-of-service.
To Next Page
Loading...
