Maintenance Object Repair Procedures
555-233-123
10-1710 Issue 4 May 2002
Table 10-626. TEST #294 or #295 Idle Time Slot Test on TDM Bus A or TDM Bus B
Error
Code
Te s t
Result Description/Recommendation
none ABORT Could not allocate the necessary system resources to run
this test. For example, maintenance could be running on the
Tone Detector circuit pack and it is using the CPTRs.
1115 ABORT Could not allocate the necessary system resources to run
this test.
1. Retry the command at 1-minute intervals a maximum of
5 times.
number FAIL The error code indicates the number of bad time slots that
were detected. The cause of this failure is most likely due to a
bad port circuit pack and not the TDM Bus itself.
1. Execute the command again.
2. If the error persists, check the Error and Alarm Logs for
alarms on port circuit packs from the NPE Crosstalk Test.
3. Refer to the appropriate circuit pack’s documentation to
clear the circuit pack’s problem.
4. Test the TDM Bus again. If the error continues, refer to
the ‘‘TDM Bus Fault Detection and Isolation Procedure’’
described earlier.
PASS The success of this test indicates all the idle time slots that
are supposed to be idle are indeed idle. There is no noise on
any of the idle time slots.
Continued on next page
To Next Page
Loading...
