TIE-DS1 (DS1 Tie Trunk)
Issue 4 May 2002
10-1743 555-233-123
1004 ABORT The port was seized by a user for a valid call. Use display port
UUCSSpp to determine the trunk group/member number of
the port. Use status trunk to determine the service state of the
port. If the service state indicates that the port is in use, then
the port is unavailable for certain tests. You must wait until the
port is idle before retesting.
1. If the port status is idle, retry the command at 1-minute
intervals for a maximum of 5 times.
1020 ABORT The test did not run because of a previously existing error on
the specific port or a more general circuit pack error.
1. Examine the Error Log for existing errors against this port
or the circuit pack and attempt to diagnose the already
existing error.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2053 ABORT At least one of the following errors is found on the DS1 circuit
pack: 1281—Loss of signal, 1793—Blue Alarm, 2049—Red
Alarm, 2305—Yellow Alarm, 1537—Hyperactivity.
Look for the above error types in the Hardware Error Log and
follow the procedures given in the appropriate DS1-BD or
UDS1-BD maintenance documentation for the listed error
types.
Table 10-642. TEST #6 NPE Crosstalk Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
