Maintenance Object Repair Procedures
555-233-123
10-1762 Issue 4 May 2002
Table 10-647. TEST #6 NPE Crosstalk Test
Error
Code
Te s t
Result Description/Recommendation
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at one minute intervals a maximum of
5 times.
1000 ABORT System resources required to run this test are not available.
The trunk may be busy with a valid call. Use display trunk xx
to determine the trunk group/member number of the port. Use
status trunk to determine the service state of the port. If the
service state indicates that the port is in use, the port is
unavailable for certain tests. (Refer to “Status Commands”
section in Chapter 8, ‘‘Maintenance Commands and
Trouble-Clearing Aids’’ for a full description of all possible
states.) You must wait until the port is idle before retesting.
1. If the port status is active, but the port is not in use (no
connected ports), check the Error Log for Error Type 1025
(see Error Log table for description of this error and
required actions). The port may be locked up.
2. If the port status is idle, retry the command at 1-minute
intervals a maximum of 5 times.
1001 ABORT System resources required to run this test are not available.
This could be due to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1002 ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or it may have
time slots out-of-service due to TDM-BUS errors. Refer to
TDM-BUS Maintenance to diagnose any active TDM-BUS
errors.
1. If the system has no TDM-BUS errors and is not handling
heavy traffic, repeat test at 1-minute intervals a maximum
of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors
present or some Tone Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer
to TTR-LEV Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer
to TONE-PT Maintenance documentation.
3. If neither condition exists, retry the test at one minute
intervals a maximum of 5 times.
Continued on next page
To Next Page
Loading...
