Maintenance Object Repair Procedures
555-233-123
10-1816 Issue 4 May 2002
Processor replacement procedure screens
Screen 10-17. Maintenance-related system parameters (change system-parameters
maintenance)
7. Avaya services resets
the translation ID
reset
translation-id
Avaya Services executes the
command. Distributors or third-party
vendors must also contact Avaya
Services.
NOTE:
The system message, Cannot
reset translation-ID
without standby SPE
being accessible, means
that both processors must be
sane and operational.
8. Switch to the A-side reset system
interchange
Switches SPE control to the active, or
A-side.
9. Repeat for High and
Critical Reliability
systems
Go back to Steps #3 through #8, this
time performing the steps on the
A-side.
Table 10-660. Processor circuit pack replacement procedure — Continued
√ Step Description Command Procedure
Continued on next page
change system-parameters maintenance Page 1 of 2 SPE B
MAINTENANCE-RELATED SYSTEM PARAMETERS
OPERATIONS SUPPORT PARAMETERS
Product Identification: 1501137003
First OSS Telephone Number: Abbrev Alarm Report? y
Second OSS Telephone Number: Abbrev Alarm Report? n
Alarm Origination to OSS Numbers: neither
Cleared Alarm Notification? n Suspension Threshold: 5
Restart Notification? n
Test Remote Access Port? n
CPE Alarm Activation Level: none
Customer Access to INADS Port? n
Repeat Dial Interval (mins): 7
SCHEDULED MAINTENANCE
Start Time: 01 : 00 Stop Time: 01 : 01
Daily Maintenance: daily Save Translation: no
Control Channel Interchange: daily System Clocks Interchange: daily
SPE Interchange: daily
To Next Page
Loading...
