UDS1-BD (UDS1 Interface Circuit Pack)
Issue 4 May 2002
10-1869 555-233-123
1303 FAIL The DS1 circuit pack Suffix is incorrect for CSU Module/T1 Sync
Splitter or E1 Sync Splitter administration.
The DS1 circuit pack Suffix is incorrect for CSU Module/T1 Sync
Splitter administration. The
Near-End CSU Type field on the
add ds1 form has been administered as
integrated but the
DS1 circuit pack is not a TN464F or later suffix UDS1 board.
1. If the CSU Module/T1 Sync Splitter is to be used, and the
Near-End CSU Type field is set to integrated to
allow for CSU Module/T1 Sync Splitter administration,
remove the circuit pack and replace it with a TN464F or later
suffix board. Otherwise use the change ds1 command to
change the
Near-End CSU Type field to other.
The DS1 circuit pack Suffix is incorrect for E1 Sync Splitter
administration. The E1 Sync-Splitter? field on the add
ds1 form has been administered as
y but the DS1 circuit pack is
not a TN464F or later suffix UDS1 board.
1. If the E1 Sync Splitter is to be used, and the E1
Sync-Splitter?
field is set to y to allow for E1SS
administration, remove the circuit pack and replace it with a
TN464F or later suffix board. Otherwise use the change ds1
command to change the
E1 Sync-Splitter? field to n.
1310 FAIL The DS1 Board Loopback (BLB) demand test (#1209) failed.
1. Repeat the test using the test ds1-loop UUCSS
ds1/csu-loopback-tests command.
2. If the BLB test continues to fail, then replace the UDS1-BD
circuit pack.
3. Run this test again.
Table 10-673. TEST #138 Loss of Signal Alarm Inquiry Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
